Always check for obstacles before operat- ing in a new area. See the specifications section beginning on page 162 for capacities. Allow the engine to warm up for approximately five minutes. Wheel Hub Tightening Front wheel bearing tightness and spindle nut retention are critical component operations. Dennis Kirk has been the leader in the powersports industry since 1969, so you can rest assured that we have your back when it comes to bringing you the best 2011 Polaris Outlaw 90 products.
It also prevents bacterial growth and pro- motes better starting after the storage period. Turn the fuel valve off. Use the following instructions to dry it out before operating. Follow the mixing directions on the container. Place a drain pan under the engine crankcase. The rear tires should be slightly off the ground. To pre- vent serious injury, do not operate vehicle with guard removed.
See the Pre-Ride Check- Rear suspension Daily list. Shift the transmission to neutral. Nov 06, 2017 Sounds like you have a stuck float needle in the carbs 2. Follow the instructions on the container. Place the transmission in gear.
Always follow proper procedures for an overturn. Do not operate on excessively rough, slippery or loose terrain. Always drive within the sight of an adult. The left lever controls the rear brake. Turn the fuel valve on. It cleans the fuel system, the combustion chamber and the exhaust ports. Grease all zerk fittings immediately after washing.
The left lever controls the rear brakes. Secure the fuel cap, oil cap and seat. Always follow all tire maintenance procedures as outlined in this manual and on the labels on the vehicle. Apply the brakes lightly for stopping. Do not install it in any other prod- uct.
While running he can turn each dime size screw in or out to adjust the idle. Use caution and drive at reduced speeds in conditions of reduced visibility. Be constantly alert for hazards such as logs, rocks and low hanging branches. Avoid steep hills 15° maximum. Allow it to idle for two to three minutes.
The tip should not be white. Check battery voltage each month during storage and recharge as needed to maintain a full charge. Use a non-synthetic brush to clean the arrester screen. Most all of the manuals are in English but some are not. Some states do not allow limitations on how long an.
Never fied service dealer inspect the entire attempt wheelies, jumps, or other stunts. Maintain the oil level in the proper range. It contains important safety information. If it's unavoidable, follow these precautions: 1. Apply the brakes until the vehicle stops moving. Clutches drive and driven 12 M 1000 1600 Inspect;.