My bet is the rodents were your culprit. !! Turned it off and tried cranking again and it was hard starting again. The new chassis provides a solid base that results in a remarkably smooth ride for such a large, truck-based vehicle, and the braking and steering is much improved over the 2006 model. It would barely limp along, so we headed for my brother in laws place. After a quick investigation I found where the little tree rat had chewed through all 3 wires associated with the Cam Position Sensor! We are dedicated to provide the best selection, the latest cutting edge technology, and the best overall shopping experience. The crank sensor is above the starter.
Take the oem numbers off your correct O2 sensor that is faulty and replace with exactly what is assigned to replace it. I took it as a given that the battery would be toast but that has been 2 years and it is still working fine. Cabin refinements are some of the best in its segment. If you've unhooked the battery for a time or did any work to the electrical system recently a relearn will probably fix the problem. A break or a short is quite possible. If you've unhooked the battery for a time or did any work to the electrical system recently a relearn will probably fix the problem.
Even the radio presets stayed. A new squirrel nest is wayy out back by the garden up in a large tree. Kwiksen oxygen sensor is designed to detect the amount of oxygen in the exhaust stream. Go get my code reader and get a P0341 which I promptly clear and try starting again to see if I get the code immediately which I do. Went to start the truck today and for the first time ever it didn't want to start. We dug it out and jumped it, it did start and run but showed fault code of reduced engine power or some such.
I believe that the cam on these engines has a little wheel mounted on the end that talks to this sensor, maybe that has worked loose? Perform 4 deceleration cycles, without using the brakes, of 25 seconds each where no specific speed is necessary. The cam position sensor is top of the block, rear drivers side. They have a learn feature on the computer and you should start and let idle for 15 minutes or more for it to reset if the battery is removed or goes dead. Probably have to pull the intake to get it off. It's been running fine until today. It is about 25 miles home, I still had a check engine light when I pulled into bro in laws place so we were going to scan it, but I did one more shut down and restart and it was fine. I think it covers the cam too.
The codes P0030 and P0053 were relevant to bank 1 sensor 1 oxygen sensor issue. A new squirrel nest is wayy out back by the garden up in a large tree. Could it be just the sensor? Might also make the Miss's happier and not in your case about fixing the damn thing every week. The Yukon is also able to tow up to 8,200 pounds and has a payload capacity of nearly a ton, meaning buyers don't have to choose between utility and luxury. These sensors were direct replacement for the ones installed on the vehicle original equipment.
Optional 20-inch aluminum rims are available and add a modern look with little deterioration of the ride. You get a range of different sized sockets that you can use for your vehicle for easy access and removal of your 02 sensors. Along the way I stopped twice, shut it off and then started it back up. I'm guessing I can test the sensor. The crank sensor is above the starter. Check the wires and connector going to the sensor. Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute.
I blamed an ignorant coyote thinking it stepped on a snake. The sensor was a perfect fit. . I think it covers the cam too. Even the radio presets stayed. I do have a scan tool, good multimeter. It is about 25 miles home, I still had a check engine light when I pulled into bro in laws place so we were going to scan it, but I did one more shut down and restart and it was fine.