Pull the lever towards you to deactivate. Rotate the seatback until you hear a click, locking it in the upright position. If this message does not clear within a short present. If failure repeats, bring your vehicle to your authorized dealer to have the new key s programmed. Check with your authorized dealer for availability.
Using your vehicle as an ambulance Do not use this vehicle as an ambulance. Ford may change the contents without notice and without incurring obligation. This increases traction which may enable you to safely drive over terrain and road conditions that a conventional two-wheel drive vehicle cannot. Remove the bulb socket from the lamp assembly by turning counterclockwise and pull the bulb straight out. The passenger cannot protect the child from injury in a collision. If the warning stays on or continues to come on, have the system inspected by your authorized dealer. The brightness display will only appear when the menu is not displayed.
Check with your authorized dealer for availability. To obtain reimbursement information, U. A display bar will appear at the bottom of the screen indicating the brightness levels. Additional electrical equipment may be required. Displayed when the Tire Pressure Monitoring System is malfunctioning. The running average fuel economy is reinitialized to a factory default value if the battery is disconnected. If the ignition system gets wet, the vehicle may stall.
This message should disappear shortly. Twist a thin coin between the two halves of the remote entry transmitter near the key ring. If the dissimilar spare tire or wheel is damaged, it should be replaced rather than repaired. Reverse steps to reinstall bulb s. Always open the garage door before you start the engine. Turn all other accessories off.
D Drive with Overdrive The normal driving position for the best fuel economy. The control buttons are located on the driver-side rear quarter trim panel accessible from the liftgate area. To unfasten, push the release button and remove the tongue from the buckle. It will help you fix every part of it. We provide the that you can view or download free from here. About Ford Motor Company is an automotive manufacturer from the United States, established by Henry Ford at the Michigan, Detroit. Refer to the payload description and graphic in the Vehicle loading — with and without a trailer section.
Collecting and storing data during a crash or near crash event, recorded information may assist in the investigation such an event, the modules may record information about both vehicle. All of Chilton's online content for the 2007 Ford Explorer Sport Trac is updated monthly, so you'll have the most recent information on hand for any Do-It-Yourself project. If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount. The heater can be plugged in the night before starting the vehicle. To access your saved stations, press the corresponding memory preset. Fully install the engine oil filler cap by turning the filler cap clockwise until three clicks can be heard.
In the other side, the user manual may help the consumer before decide to buy the product. Remove the bulb holder from the lamp assembly by depressing the snaps. Lower the wheel by turning the jack handle counterclockwise. Why to buy Digital Service Manual from us? This will automatically return the vehicle to the previously set speed. Displayed when the liftgate or the liftgate glass is not completely closed. Remove fuel filler cap slowly. Refer to Safety Canopy system later in this chapter.
Contact your authorized dealer as soon as possible. Our 2007 Ford Explorer Sport Trac repair manuals include all the information you need to repair or service your 2007 Explorer Sport Trac, including diagnostic trouble codes, descriptions, probable causes, step-by-step routines, specifications, and a troubleshooting guide. Check with your authorized dealer for availability. Refer to Engine coolant in the Maintenance and Specifications chapter. Do not use fuel lines, engine rocker covers or the intake manifold as grounding points. Use 2 Second to start-up on slippery roads or to provide additional engine braking on downgrades. Do not tow with a slingbelt.
If all remote entry transmitters are not present during the programming procedure, the transmitters that are not present during programming will no longer operate the vehicle. Ford recommends the use of a child safety seat having a top tether strap. Lift the seatback toward the rear of the vehicle. You may change the active channel by pressing the A or B headphone control button. Remove the bulb holder from the lamp assembly by depressing the snaps. In a crash, one anchor may not be strong enough to hold two child safety seat attachments and may break, causing serious injury or death.