Ford design rear axles contain a synthetic lubricant that does not require changing unless the axle has been submerged in water. The hazard flashers will operate when the ignition is in any position or if the key is not in the ignition. Pull the lever towards you to deactivate. Remove the four screws from the top and bottom front of the headlamp assembly. Vehicle line, series, body type 4. They also have a couple of different Ford service manuals for your engine, diagnostics and repair.
Release the button and pull down on the height adjuster to make sure it is locked in place. Pull down the latch lever located on the bottom seat back to fold the seat back forward. . The reading lamps can be turned on by pressing the rocker controls next to each lamp. If the procedure needs to be repeated, you must wait 30 seconds. Refer to Lubricant specifications in this chapter.
You may need to pull the seatback forward to access the tether anchors. If mechanical aimers are used and the cross-car sight line is in any way blocked, set the legs of the universal adaptor all to the same setting, such that the cross-car sight line is no longer blocked, per the instructions for the brand of mechanical aimer used. Reach behind the rear bumper to locate the bulb. Fully apply the parking brake, then shift into 1 First. Dana rear axles also contain a synthetic lubricant but do require a change. Yellow area warning — the transmission fluid is higher than normal operating temperature. The storage compartment may be used to secure sunglasses or a similar object and the front tab can be used for holding tickets, paper, envelopes, etc.
Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death. Fully insert the jack handle through the bumper hole and into the guide tube. Remove the jack and fully tighten the lug nuts in the order shown. Locate and carefully remove the engine oil level indicator dipstick. Each number must be entered within five seconds of each other. Make sure the parking brake is fully set.
The definitions of these items are listed below. If no leaks are apparent, reset the switch by pushing in on the reset button. If the dissimilar spare tire or wheel is damaged, it should be replaced rather than repaired. Loosen each wheel lug nut one-half turn counterclockwise but do not remove them until the wheel is raised off the ground. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. Install the child safety seat tightly using the vehicle belts. Temperature selection: Controls the temperature of the airflow in the vehicle.
Refer to Lubricant specifications in this chapter. Your keys are programmed to your vehicle; using a non-programmed key will not permit your vehicle to start. Ford design rear axles contain a synthetic lubricant that does not require changing unless the axle has been submerged in water. Modulate the temperature control to maintain comfort. Install and tighten the fill plug securely.
Load equalizing hitch When hooking up a trailer using a load equalizing hitch, always use the following procedure: 1. Breathing gasoline vapors, or skin contact could cause an adverse reaction. The indicator light on the instrument cluster will turn on. Reinstall rubber diaphragm and cap onto reservoir. Transmission fluid dipstick automatic transmission 2. Use only fluid that meets Ford specifications.
Do not pile cargo higher than the seatbacks to reduce the risk of injury in a collision or sudden stop. Use with recirculated air to improve cooling performance and efficiency. Installing the snowplow Weight limits and guidelines for selecting and installing the snowplow can be found in the Ford Truck Body Builders Layout Book, Snowplow section, found at www. The tires may fail and injure a passenger or bystander. It is the responsibility of the customer to ensure that the trailer brakes are adjusted appropriately, functioning normally and all electric connections are properly made. High beams: Illuminates when the high beam headlamps are turned on. Away from home If you own a Ford or Mercury vehicle and are away from home when your vehicle needs service, or if you need more help than the authorized dealer could provide, after following the steps described above, contact the Ford Customer Relationship Center to find an authorized dealer to help you.