Buckle the combination lap and shoulder belt. Tire rotation Rotating your tires at the recommended interval as indicated in the scheduled maintenance information that comes with your vehicle will. If it is necessary to relocate the trailer hitch ball position, a frame-mounted trailer hitch must be installed. Recirculation can be engaged manually in any other airflow selection except defrost. This maximizes the effectiveness of the safety belt and removes any slack from the safety belt to improve protection. For more information on Ford Motor Company and its products visit, additional owner information is given separate publications, this Owner's Guide describes every option model variant available, and therefore some of the items covered may not apply your. To increase airflow to the outer instrument panel vents, close the vents located in the middle of the instrument panel.
Also use in menu mode to select various settings. Installing child safety seats in the front row lap belt seating positions SuperCab and SuperCrew Installing a child safety seat in the front row lap seating position should be avoided if at all possible. This will automatically return the vehicle to the previously set speed. This system helps you maintain steering control during emergency stops by keeping the brakes from locking. If this warning message is displayed, check the level of the engine oil.
Safety switch will automatically cut off the fuel supply, shut-off switch in Roadside Emergencies chapter, this guide, answers to such questions contained comments, highlighted by the warning triangle symbol. Overdrive off if equipped : Illuminates when the overdrive function of the transmission has been turned off, refer to the Driving chapter. They may cause squeaking, chatter noise, streaking and smearing. Pull the round knobs on each side of the extender to unlock it. Do not use supplemental transmission fluid additives, treatments or cleaning agents.
The front passenger outboard and rear outboard seat safety belts have two types of locking modes described below: Vehicle sensitive mode The vehicle sensitive mode is the normal retractor mode, allowing free shoulder belt length adjustment to your movements and locking in response to vehicle movement. Allow the safety belt to retract to remove any slack in the belt. To access this information, special equipment must be directly connected to the recording modules. Do not hold for longer that 30 seconds. Simultaneously press and hold both the HomeLink and hand-held transmitter button. Compass display The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Slide the headlamp assembly forward disconnecting the snap attachment at the fender.
Press and hold the bottom part of the rocker switch to open the window. Your vehicle has larger tires and increased ground clearance, giving the vehicle a higher center of gravity than a passenger car. Insert the belt tongue into the proper buckle for that seating positions until you hear a snap and feel it latch. Sitting on the safety belt will increase the risk of injury in an accident. Refer to Lubricant specifications in this chapter.
If you are uncomfortable - try different positions for the safety belt upper anchorage and seatback which should be as upright as possible;. Transmission fluid requirements are indicated on the dipstick or on the dipstick handle. When refueling always shut the engine off and never allow sparks or open flames near the filler neck. Do not tow with a slingbelt. The belt is now ready for use. Install and tighten the fill plug securely. Loaded vehicles may handle differently than unloaded vehicles.
The speed rating denotes the speed at which a tire is designed to be driven for extended periods of time under a standard condition of load and inflation pressure. Route the tether strap behind the head restraint supports to a loop behind an adjacent seating position, and hook the strap hook onto the loop. Do not put anything on or over the airbag cover 1. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Notice to owners of pickup trucks and utility type vehicles Utility vehicles have a significantly higher rollover rate than other types of vehicles. Do not use your vehicle for snow removal until it has been driven at least 500 miles 800 km.
Text: This control currently not supported. Refer to your scheduled maintenance information to determine the correct service interval. Many lights will illuminate when you start your vehicle to make sure the bulb works. Move the transfer case lever through N Neutral directly to the desired position. Clutch fluid reservoir manual transmission 3. Insert the belt tongue into the proper buckle for your seating position until you hear a snap and feel it latch.