Install the piston pin A. Set the temperature control dial to maximum. These files contain detailed information about your vehicle, and can be downloaded, searched, and printed. Clean the mounting surface and fluid passages of hanger. Reinstall the fuel fill cap.
Shift to the R position. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Install a new set ring on the end of each driveshaft, 21. Troubleshooting Information see page 14-3 before you troubleshoot. For a printed owner's manual, click on authorized manuals or go to www.
With a hammer and special tools, install a new Rotor Slip Ring Test front bearing in the drive end housing. Support the stator housing in a vise, and drive out Rectifier Test the front bearing with a brass drift A and hammer. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. By September 1997, the Odyssey had sold more than 300,000 units, becoming Honda? Check and, if necessary, adjust the valve clearance on No. Lower the hoist, then remove the upper radiator cooler hoses and lines. Remove the locknut, and take off components down to the reverse selector hub. Disconnect the 2P connector from the shift control 11.
Measure resistance between injector 2P connector 43. Measure resistance between the terminals of the indicated sensor see table. When worn or damaged I. Hg 07746-0010300 Attachment, 42 x 47 mm 07749-0010000 Driver. Install the valve spring and valve retainer. Disconnect the battery also from the starter body. Install new set ring A on the intermediate shaft B.
If the cylinder block is to be reused, hone the cylinders and remeasure the bores. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Torque Converter, Gears, and Clutches The torque converter consists of a pump, turbine, and stator assembly in a single unit. Use the Maintenance Schedule for Severe Conditions if the vehicle meets any of the qualifiers in the Severe Conditions schedule or if the vehicle is normally driven in Canada. Remove the intake manifold see page 9-4. Measure the voltage between the 3rd clutch securely supported. Also, as grade logic control system has been adopted to control shifting in the D and D3 positions.
Replacement body parts have generic self-adhesive labels. Remove the old oil seal from the oil pump. Sensor Circuit High Voltage 9. Remove the battery clamp bolt from the back cover. Open the throttle fully, then crank the engine with 2. Remove the intake manifold cover A and ignition 2.
Install the special tools on the clutch assembly. Countershaft Speed Sensor Circuit 8. Remove the mounting bolt and the shift solenoid valve B. Install the steering gearbox mounting bolt A and 28. Install the back cover A , then install the camshaft Install the cylinder heads in the reverse order of pulley B. Loosen the locknut A , then disconnect the 1.
Inf ants, young children, and short adults are at the greatest risk. Remove the locknut, and disassemble the shaft and gears. Clutch Solenoid Valve Circuit 6. Disconnect the oil pressure switch connector, then remove the oil pressure switch. Ignition timing At idle check. Install the cylinder head covers.
Remove the side engine mount bracket. Install switch harness 2P connector. Release the vacuum, then apply vacuum again. Remove the intake manifold cover and intake manifold see page 9-4. Remove the drive plate A and washer B from the engine crankshaft.