Release clutch slowly while pressing down slowly on the accelerator pedal. Do not make any unauthorized changes to the vehicle or engine. If you need to use the above procedure, it is possible that a fuse has blown and your brakelamps may not be functioning. Buckle the combination lap and shoulder belt. Check your safety belt system periodically to make sure that it works properly and is not damaged.
Do not fill above this line. Store the center safety belt in the opening on the seat back. See your Ford or Lincoln-Mercury dealer. Take your vehicle to a service facility as soon as possible to minimize engine damage. Passenger air bag deactivate switch This switch must be used to deactivate the passenger air bag whenever a child seat is used in the right front or center front. Bring the vehicle to a stop.
Ensure that the seat is relatched into place. Press switch to tilt the rear of the seat up or down. Do not grip the spokes. Push the release lever forward while removing the key from the ignition. Clean the reservoir cap before removal to prevent dirt and water from entering the reservoir. The driver safety belt is buckled The safety belt indicator light and while the indicator light is.
It also arms and disarms the anti-theft system for more information on the anti-theft system, refer to Anti-theft system. To connect the safety belt, insert the tongue into the buckle. Turn control up to increase delay. Switch off any unnecessary electrical equipment. Clutch fluid reservoir if equipped 5.
Do not reduce the tire pressures but shift to a lower gear and drive steadily through the terrain. If the transmission and transfer case are submerged in water, their fluids should be checked and changed, if necessary. Position the vehicles so that they do not touch one another. Do not tow with slingbelt equipment. Anti-theft system if equipped When armed, the anti-theft system prevents unauthorized entry into your vehicle.
Refer to Air suspension load leveling in the Driving chapter for more information. If you choose to install a child safety seat in the front passenger seat, move the seat as far back as possible. If your vehicle speed is faster than the set speed while driving on a downhill in Overdrive, you may. . To avoid scratching the lamps, do not use a dry paper towel, chemical solvents or abrasive. Use only extensions manufactured by the same supplier as the safety belt. Use 1 First gear and set the parking brake fully.
If a light fails to illuminate, have the vehicle serviced. When the passenger air bag switch is turned off, the passenger air bag will not inflate in a collision. To prevent electrical shock, do not use your heater with ungrounded electrical systems or two-pronged cheater adapters. If a bulb is removed for an extended period of time, contaminants may enter the lamp and affect performance. If the parking brake is fully released, but the Brake System light remains on, have the brakes checked immediately.
Apply the accelerator slowly and avoid spinning the wheels. If your vehicle is particularly dirty, use a quality car wash detergent. It is not designed to stop a moving vehicle. Safety belt Illuminates when the ignition is switched on to remind you to fasten your safety belts. Overdrive — The normal driving position for the best fuel economy.
Replacing the batteries The transmitter is powered by two coin type three-volt lithium batteries. The indicator light under the autolamp control illuminates when the autolamps are activated. While applying downward pressure on the hood, push the hood latch handle located just left of the center of the hood. Refer to Capacities and specifications. Windshield washer fluid reservoir 4. Do not drive if you smell exhaust fumes. Pull headlamp control towards you to turn foglamps on.